Regulation of Fuel Quantity
As a result of the on-demand regulation of fuel flow capacity, fuel heating in
the tank is reduced. This is achieved by the DME control module switching on fuel
pump 2 only as required, while fuel pump 1 is always activated. With the following
switching criteria, fuel pump 2 is additionally switched on to increase flow capacity.
At engine start and then 2 seconds run-on (with a hot start 5 seconds run-on).
With a calculated fuel consumption of > 50 liters/hour the pump is switched on,
and at < 45 liters/hour switched off again. With a fill level of < 10 liters in the tank,
it is switched on and with > 15 liters it is switched off again.
Добавлено через 4 минут(ы) 28 секунд(ы)
Нажмите на эту панель, чтобы увидеть изображение в оригинальном размере.
Добавлено через 5 минут(ы) 53 секунд(ы)
1. В общем второй бензонасос включается при потреблении выше 50 литров и выключается при снижении потребления ниже 45 л на 100 км.
2. Второй бензонасос включается при остатке топлива в баке менее 10 литров. Выключается при наличие более 15 литров
Причиной переключения на второй бензонасос (при достаточном количестве топлива) может быть неправильное показание уровня топлива